TM 10-3835-223-13&P
5-7. ELECTRICAL ENCLOSURES REPAIR - cont.
(3)
Installation. Install the enclosure (junction box) as follows:
(a)
(b)
(c)
(d)
(e)
(f)
(g)
(h)
(i)
(j)
Position enclosure (5) on power pack weldment (22).
Install four lock washers (11), washers (10) and screws (12).
Position cable assembly (16) in enclosure (5). Install lock nut (18) on connector (17).
Repeat step (c) for cable assemblies (15 and 14).
Connect ground wire with screw (13).
Position connector (1) and cable assembly (2) in enclosure (5). Install ferrule (231 on
connector.
Repeat step (e) for six remaining corrugated (ribbed) cable assemblies
(9,8,7,6,4, and 3).
Connect electrical wiring to terminal board TB-1(24) as marked. (Refer to
electrical schematic on enclosure lid.)
Remove tags.
Lower enclosure lid (21), position two brackets (20) over lid edge, and tighten two
screws (19).
5-20
