TM 10-3835-223-13&P
2-7. OPERATING PROCEDURES
These procedures consist of the following instructions:
a. Hose Deployment (page 2-15)
b. Hose Retrieval (page 2-18)
WARNING
Be completely familiar with the operating procedures before using the
equipment.
a.
Hose Deployment.
(1)
Verify that brakes on both reels are applied.
WARNINGS
l To prevent injury to personnel or damage to the equipment , observe the
following :
l Remove rings, bracelets, wrist watch and neck chains before starting work.
Jewelry can catch on equipment and cause injury or may short across an
electrical circuit and cause severe burns or electrical shock. Secure all loose
clothing.
l Do not operate the unit with guard panels removed.
l Operator must monitor hose reel speed at all times. Do not let hose come off
reel to fast.
NOTES
l
Hose deployment works best if system is operated from rough terrain
forklift or similar vehicle. Hose is unwound as vehicle hauls hose reel
system through installation site.
l
One power pack is supplied for use with six hose reel frame units. Power
pack must be installed to make reels operational. Operating instructions
are the same for all six frame units.
(2)
Position hose reel system on flatbed truck, rough terrain forklift, or other suitable vehicle.
Secure frame unit to vehicle. Transport to first connection point.
NOTE
Electrical power is not required to unreel hoses; however, power should be
available in case hose must be retrieved or adjusted.
(3)
Connect slave cable (power cable) to 24Vdc vehicle power source. Use the supplied cable
adapter, ifrequired.
NOTE
DO NOT remove fold from hose end.
(4)
Position loose end of hose between upper and lower frame rollers.
2-15
