TM 10-3835-223-13&P
Section III. OPERATION UNDER USUAL CONDITIONS
Page
Assembly and Preparation for Use
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2-10
Operating Procedures . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2-15
Preparation for Movement
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2-24
2-6. ASSEMBLY AND PREPARATION FOR USE
a. Powerpack Installation.
WARNINGS
l This equipment produces hydraulic pressure in excess of 1500 psi. Verify
that all pressure hoses are properly connected before operation. A connection
that detaches can cause injury.
l Do not disconnect hydraulic hose couplings when system is under pressure.
Failure to comply may result in injury to personnel and damage to
equipment.
l Remove rings, bracelets, wrist watch and neck chains before starting work.
Jewelry can catch on equipment and cause injury or may short across an
electrical circuit and cause severe burns or electrical shock. Secure all loose
clothing.
l To prevent injury to personnel, the operator must monitor reeling operations
at all times. Use extreme caution when retrieving fuel hose, Personnel may
be caught between fuel hose and hose reel if system is operated too quickly.
Keep clear of all moving parts.
l The power-pack is heavy. Four personnel are required to lift, carry and
position the powerpack in the frame unit.
CAUTION
Do not untie or unwrap crimp from end of fuel hoses. Removing crimp will
allow air to enter hose and make deployment difficult. Remove crimp only
after hoses are fully deployed.
NOTE
Verify that hose reel brakes are applied before moving equipment. Hose reels
may turn, causing hose to spill from reels.
(1)
Working from the brake lever side of the frame unit, position powerpack so that hydraulic
disconnects are pointing away from frame.
(2)
Slide powerpack into guides approximately half way into frame unit.
(3)
Carefully pull control cable from powerpack. Position control cable switches away from
hydraulic hoses.
2-10
