TM 10-3835-223-13&P
2-8. PREPARATION FOR MOVEMENT
This paragraph contains procedures for the following:
a.
Power Pack Removal (page 2-24).
b.
Stacking (page 2-27).
WARNINGS
l This equipment produces hydraulic pressure in excess of 1500 psi. Verify
that all pressure hoses are properly connected before operation A connection
that detaches can cause injury.
l Do not disconnect pressure hose couplings when system is under pressure.
Failure to comply may result in injury to personnel and damage to
equipment.
l Remove rings, bracelets, wrist watch and neck chains before starting work.
Jewelry can catch on equipment and cause injury or may short across an
electrical circuit and cause severe burns or electrical shock. Secure all loose
clothing.
CAUTION
Do not untie or unwrap fold from end of fuel hoses. Removing fold will allow
air to enter hose and make deployment difficult.
NOTE
Verify that hose reel brakes are applied before moving equipment. Hose reels
may turn, causing hose to spill from reels.
a.
Power Pack Removal.
(1)
Disconnect slave cable from vehicle power source. If used, store cable adaptor.
(2)
Disconnect slave cable from power pack.
(3)
Disconnect control cable assembly from power pack.
(4)
Disconnect four frame unit hydraulic hoses from power pack.
CAUTION
To prevent system contamination and early failure of equipment, wipe all dirt
from quick disconnect fittings.
(5)
Wipe dirt from quick disconnect fittings using a clean, soft cloth. Wipe spilled hydraulic
fluid from power pack.
(6)
Install protective caps on all quick disconnect coupling ends.
(7)
Stow control cable assembly in power pack.
2-24
