TM 10-3835-223-13&P
4-13. CONTROL CABLE ASSEMBLY REPLACEMENT.
This task consists of:
a. Removal
b. Installation
INITIAL SET-UP:
Equipment Condition:
Slave cable disconnected from power source (para. 2-8a.).
a.
Removal.
(1)
Unscrew knurled ring of connector plug (1) from power pack receptacle (2).
(2)
Pull connector plug (1) from receptacle (2). Install protective cap on receptacle (2).
b.
Installation.
(1)
Remove protective cap from power pack receptacle. Aline replacement cable assembly
connector plug (1) with receptacle (2). Make sure connector pins line up correctly with
receptacle.
(b)
Screw knurled ring of connector plug (1) onto receptacle (2).
4-20
