TM 10-4130-237-14
5-4.
STARTER REPAIR (CONT)
5
6
7
8
9
1
0
1
1
1
2
1
3
1
4
1
5
Install drive cap over end of armature.
Install and hand-tighten starter motor thru bolts.
Torque thru bolts to 45 to 55 in. lb (5.1 to 6.2 Nm).
Install two drive cap mounting bolts and two lockwashers.
Install clutch and pinion gear with beveled edge of gear away from starter.
Install spring cup.
Install return spring.
Install retainer.
Install roll pin to armature shaft.
Install plastic cap on starter assembly. Cap should lock in position when properly assembled.
Install starter (para 4-27).
5-18
