TM 10-4130-237-14
6-2.
CYLINDER BLOCK ASSEMBLY REPAIR/OVERHAUL (CONT)
39 Position valve seat puller so puller body does not rest on valve seat
40 Tighten valve seat puller bolt until valve seat is pulled out of cylinder.
41 Position crankcase on right cylinder.
42 Repeat steps 31 through 40 for left cylinder.
43 Place crankcase on left cylinder assembly.
44 Install new intake valve seat to right cylinder assembly.
NOTE
Make sure chamfered edge of valve seat goes down into cylinder.
45 Using driver, drive new seat until it bottoms. Seat will be slightly below cylinder head gasket surface.
6-16