TM 10-4130-237-14
4-4.
c.
4-5.
a.
b.
c.
4-6.
a.
b.
UNPACKING AND INSPECTION (CONT)
Inspection Upon Receipt of Shipment. Inspect water chiller for loose or missing screws and fasteners and for bent,
dented, cracked, or broken components. Inspect air intakes/grills for debris and damage. Perform monthly (M)
preventive maintenance checks and services (PMCS).
Section III. UNIT PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS)
GENERAL
Always keep in mind the CAUTIONS and WARNINGS while performing PMCS.
Report any deficiencies using the proper forms. See DA Pam 738-750.
If the PMCS table requires removal of assemblies or equipment, refer to the maintenance procedures section of
this chapter.
PMCS PROCEDURES
Purpose. The PMCS table lists the inspections and care of the equipment required to keep it in good operating
condition.
Use. To perform PMCS, follow the directions listed for each column below.
(1) Item No. This column numbers the checks and services in order of performance. It is the source of item
numbers for the TM Number Column on DA Form 2404, Equipment Inspection and Maintenance Worksheet.
(2) Interval. This column tells you when to do a certain check or service. The codes in this column are as fol-
lows:
W Perform these checks and services once per week.
M Perform these checks and services once per month and upon receipt of new equipment.
H Perform these checks and services after the number of hours of equipment operation listed in the column.
4-4