TM 10-4130-237-14
4-11.
WIRING HARNESS REPAIR (CONT)
a. T e s t i ng
1 Prepare multimeter for continuity test.
2 Place red lead on one end of wire section to be tested. Place black lead on other end of wire section to be
t e s t e d .
3 Multimeter should display less than 1 ohm. If it does not display less than 1 ohm, replace wire.
b. Repair
NOTE
Repair of wiring harness consists of replacement of defective wire.
1 Unwrap harness cover as needed. Remove damaged wire from wiring harness.
4-19
