TM 10-4130-237-14
4-16.
PULLEY DRIVE REPLACEMENT/REPAIR (CONT)
4 Install socket-head screw in puller hole in compressor drive hub. Tighten sockethead screw while gen-
tly tapping on outer part of faceplate.
5 Tighten screw and continue tapping, until faceplate can be pushed back toward engine and free of center
hub.
6 Remove center hub and locking key from driveshaft.
7 Remove faceplate from driveshaft.
b. Assembly
NOTE
Side of faceplate with three screws faces away from engine.
1 Place faceplate on driveshaft against engine.
2 Place locking key in slot on driveshaft.
3 Aline center hub with locking key. Install center hub on end of driveshaft.
4-28