TM 10-4320-345-13
2-16. PREPARATION FOR MOVEMENT - cont.
i.
Disassemble Lead Pumping Station. Refer to figure 2-41.
WARNING
To prevent contamination of water system and damage to components, keep rocks, dirt, mud,
sand and debris from entering open couplings and hoses during disassembly.
NOTE
Refer to para 2-11d to disconnect quick disconnect coupling. Refer to para 2-11e to remove
coupling clamps.
Suction Line.
(1) Disconnect reducing wye (15) from water source.
(2) Disconnect reducing wye (15) from 6-inch x 10 foot suction hose (14).
(3) Disconnect 6-inch x 10-foot suction hose (14) from coupling half(13).
NOTE
Suction hose, coupling pipe fitting, coupling half and reducer wye are separately packaged.
(4) Remove coupling clamp (11) and disconnect assembled fitting (12) and coupling half(13) from
butterfly valve (10). If required, unscrew fitting (12) from coupling half(13).
(5) Remove coupling clamp (9) and disconnect butterfly valve (10) from suction port on 600 gpm
pump.
Discharge Line.
(6) Remove coupling lamp (7) and disconnect butterfly valve (8) from 6-inch x 20 foot discharge
hose (6).
(7) Remove coupling clamp (5) and disconnect 6-inch x 20-foot discharge hose (6) from pressure
relief valve (4).
(8) Remove coupling clamp (3) and disconnect pressure relief valve (4) from check valve (2).
(9) Remove coupling clamp (1) and disconnect check valve (2) from discharge port on 600 gpm
pump.
(10) Prepare 600 gpm pump for movement. Refer to the applicable TM.
2-91