TM 10-4610-243-13
2-15. PREPARATION FOR MOVEMENT - cont.
(14)
Disconnect tee (15) from 4-inch gate valve (14).
(15)
Disconnect 20 foot suction hose (16) from tee (15).
(16)
Disconnect tee (17) from 20 foot suction hose (16).
(17)
Disconnect tee (17) from water source.
(18)
Drain and allow components to dry.
(19)
Install caps and plugs on component couplings (para. 2-10c).
(20)
Roll up all discharge hoses and secure with tape.
(21)
Prepare hypochlorination unit (6) for movement. Refer to the applicable TM.
(22)
Prepare 350 gpm pump (12) for movement Refer to the applicable TM.
k.
Disassemble Interconnection Kits. Two interconnection kits are supplied with the water system. One kit is
located between dual tank connection kits 2 and 3 and the other between kits 6 and 7.
WARNING
To prevent contamination of water system components, keep dirt mud, sand, and
debris from entering open couplings during disassembly. Make sure protective caps
and plugs are installed after components are disassembled.
To prevent injury to personnel, water pressure must be relieved from discharge
hoses before disconnecting couplings.
Disassemble interconnection kit between dual tank connection kits 2 and 3. Refer to figure 2-35, sheet 1.
(1)
Disconnect end of 20 foot discharge hose (7) from tee (8).
(2)
Disconnect end of 10 foot discharge hose (10) from tee (8).
(3)
Disconnect tee (8) from 20 foot discharge hose (9).
(4)
Disconnect four 20 foot discharge hoses (4, 5, 6, and 7) from tee (3).
(5)
Disconnect 10 foot discharge hose (1) from tee (3).
(6)
Disconnect tee (3) from 20 foot discharge hose (1).
Dissemble interconnection kit between dual tank connection kits 6 and 7. Refer to figure 2-35, sheet 2.
(7)
Repeat steps (1) through (6) for other interconnection kit.
2-86
