TM 10-4610-243-13
4-29. TEE ASSEMBLY (9112-Y3) REPAIR - cont.
d.
Repair. Replace defective components. Do not reuse scaling components.
e
Assembly. Refer to figure 4-24.
(1)
Position gasket (25) and male coupling (24) on tee (26).
(2)
Install eight flat washers (23), screws (22), flat washers (21), lockwashers (20) and nuts (19).
(3)
Position gasket (18) and female coupling (17) on tee (26).
(4)
Install eight flat washers (16), screws (15), flat washers (14), lockwashers (13) and nuts (12).
(5)
Connect ring (9) and attached plug (10) to female coupling (17).
NOTE
Ensure gasket is fully seated in groove of coupling.
(6)
Install gasket (11) in female coupling (17).
(7)
Position gasket (8) and female coupling (7) on tee (26).
(8)
Install eight flat washers (6), screws (5), flat washers (4) lockwashers (3) and nuts (2).
NOTE
Ensure gasket is fully seated in groove of coupling.
(9)
Install gasket (1) in female coupling (7).
(10)
Install tee assembly in water system (para 3-4a).
(11)
Startup water system (para 2-12c) and check tee assembly for leaks.
4-78
