TM 10-4610-243-13
4-41.
TEE ASSEMBLIY (9115-Y) REPAIR - cont.
b.
Cleaning.
(1) Wash all components with clean water and detergent.
(2) Rinse components in clean water and dry with wiping rag.
c.
Inspection.
(1) Inspect male coupling (27) for cracks.
(2) Inspect female couplings (9 and 17) for cracks and damaged lock arms.
(3) Inspect tee (29) for cracks and corrosion.
d.
Repair. Replace defective components Do not reuse sealing components.
e.
Assembly. Refer to figure 4-39.
(1) Position gasket (28) and male coupling (27) on tee (29).
(2) Install eight flat washers (26), screws (25), flat washers (24) lock washers (23) and nuts (22).
NOTE
Ensure gasket is fully seated in groove of cap.
(3) Install gasket (20) in cap (21).
(4) Connect cap (21) to male coupling (27) with ring (19).
(5) Position gasket (18) and female coupling (17) on tee (29).
(6) Install eight flat washers (16), screws (15), flat washers (14), lockwashers (13) and nuts (12).
NOTE
Ensure gasket is fully seated in groove of coupling.
(7) Install gasket (11) in female coupling (17).
(8) Position gasket (10) and female coupling (9) on tee (29).
(9) Install eight flat washers (8), screws (7), flat washers (6) lockwashers (5) and nuts (4).
NOTE
Ensure gasket is fully seated in groove of coupling.
(10) Install gasket (3) in female coupling (9).
(11) Connect plug (2) to female coupling (9) with ring (1).
4-114
