TM10-5430-229-13&P
4-14.
STRAP ASSEMBLIES REPLACEMENT.
This Task Covers:
a. Removal
b. Cleaning
c. Inspection
d. Installation
Initial Setup:
Tools Required
None
Material's Required
Cloth, Lint-Free (Appendix F, Item 1)
Brush, Medium Bristle (Appendix F, Item 2)
Solvent, Dry Cleaning (Appendix F, Item 3)
Equipment Condition
Top cover assembly removed from tank storage chest (refer to paragraph 2-8).
a. Removal. (Refer to Figure 4-5.)
(1) Remove four hoisting straps (1) from storage area between end panel assembly (2) and storage divider pan
(3).
(2) Remove four tie-down straps (4) from storage area between end panel assembly (2) and storage divider pan
(3).
b. Cleaning.
(1) Remove all build up of dirt, oil, and debris from all surfaces
WARNING
Serious injury can result in breathing fumes of dry cleaning solvent A-A-711. Serious injury or
death can result from explosion of fumes from solvent When using this solvent:
Clean parts in a well ventilated area.
Avoid inhalation of solvent fumes and prolonged exposure of
kin to cleaning solvent Wash exposed skin thoroughly.
Do not use near open flame or excessive heat. Flash point of
solvent is 100° F to 138° F (38 C to 59° C)
Wear eye protection when blowing solvent from parts. Air pres-
sure should not exceed 30 psig (2.1 kg/cm2).
(2) Clean all metallic parts with a clean soft cloth or a medium bristle brush, and cleaning solvent.
(3) Allow parts to dry.
4-14
