TM10-5430-229-13&P
4-15.
SKID ASSEMBLY REPAIR.
This Task Covers:
a. Disassembly
b. Cleaning
c. Inspection
d. Repair
e. Assembly
Initial Setup:
Tools Required
Tool Kit, General Mechanic's (Appendix B, Item 1)
Drill, Hand, Portable (Appendix B, Item 3)
Riveter, Blind, Hand (Appendix B, Item 2)
Material's Required
Cloth, Lint-Free (Appendix F, Item 1)
Brush, Medium Bristle (Appendix F, Item 2)
Solvent, Dry Cleaning (Appendix F, Item 3)
Rivets (Appendix I, Item 4)
Lock Nuts (Appendix I, Item 5)
Lock Nuts (Appendix I, Item 6)
Rivets (Appendix I, Item 7)
Adhesive (Appendix F, Item 5)
Equipment Condition
Top cover assembly removed from tank storage chest (see paragraph 2-8).
End panels assemblies removed from tank storage chest (see paragraph 2-8).
Side panel assemblies removed from tank storage chest (see paragraph 2-8).
a. Disassembly. (Refer to Figure 4-6.)
NOTE
Steps (1) through (6) are for the removal of one cargo tie down ring assembly and one locking
pin assembly. Repeat steps as required for additional cargo rings and locking pins.
(1) Remove three cap screws (1), six flat washers (2), and three lock nuts (3). Discard lock nuts.
(2) Remove outer latch bracket (4), inner latch bracket (5), and locking pin (6) from skid (7).
(3) Drill out rivet (8) and remove spring clip (9) from outer latch bracket (4). Discard rivet.
(4) Remove cargo tie down ring (10) from nut plate (11).
(5) Remove two cap screws (12), two flat washers (13), and two lock nuts (14) from skid (7). Discard lock nuts.
(6) Remove nut plate (11) from skid (7)
(7) Drill out four rivets (15) and identification plate (16) from skid (7) Discard rivets.
4-16
