STEERINO COLUMN ASSEMBLY S-SERIES
Figure 10 - Snap Ring Removal
2.
Place the shaft assembly in a vise as shown in
Figure 11. Tap the yoke with a soft hammer
beside the bearing that is being removed. The
bearing should come out. If the bearing does
not come out, place the bearing in a vise. Use
copper Jaw covers on vise. Tap the yoke away
from the bearing as shown in Figure 12.
Figure 11 - Bearing Removal
Figure 12 - Bearing Removal
3.
Remove the spider after the bearings have been
removed.
Assembly
1.
Make certain parts are clean before assembly.
2.
Rest yoke on hard surface. Tap one bearing
part way into yoke with a soft hammer (Figure
13). Be certain bearings are straight in yoke.
Figure 13 -- Install Bearing Part Way Into Yoke
CTS-4150Y - Page 11
