SERVICE MANUALCRANKSHAFT, MAIN BEARINGS, FLYWHEEL & CRANKCASESection 6REMOVALREMOVALRemove Flywheel as follows:1.Remove the engine clutch (if equipped). (Referto respective chassis manual for engine clutch-removal procedure).2.Remove flywheel bolts. Pull off flywheel with ringgear. Support the flywheel so as not to damagethe crankshaft dowel pin.Remove the Rear Oil Seal as follows:1.ENGINES EQUIPPED w/OIL SEAL RETAINER:a.Remove the retainer (3, Fig. 6) and gasket(2).b.Press the seal (1) out of the retainer asshown.Figure 6. - Rear Oil Seal and Related Parts1. Seal and sleeve2. Gasket3. Retainer2.ENGINES NOT EQUIPPED w/OIL SEALRETAINER:a.Using a chisel, split the oil seal (1, Fig. 7),as shown.b.Remove the seal from the flywheel housing.Figure 7. - Removing Oil Seal from Flywheel Housing1. Oil SealNOTE: Be careful not to damage the seal bore in thehousing.c.Cut the wear sleeve with a muffler chisel.Be careful not to damage the crankshaftflange.d.Remove the wear sleeve.NOTE: IH recommends the Mac Tool No. MC-22 oran equivalent tool as shown in Fig. 8.CG ES-185-3PRINTED IN UNITED STATES OF AMERICAPage 6
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
