Fig. 22
Fig. 23
3.
Put the spacer washer (Item 34) in place on the
alignment tool on the inside of the case. Put the
underdrive driven gear and bearing assembly (Items
35 and 36) on the alignment tool (See Fig. 22).
Insert the sliding clutch (Item 37) into the engaged
position inside the underdrive driven gear.
4.
Install the split retaining ring (Item 39) into the
groove on the intermediate shaft (Item 38).
5.
Insert the shaft through the large opening on the
back of the case. Align with clutch splines and
engage end of shaft in alignment tool. Screw tool
and shaft together (See Fig. 23 and 24). Pull shaft
through bearings. Remove alignment tool.
6.
Install the spacer tube (Item 33), speedo gear (Item
32) and locknut (Item 31) on the end where the
alignment tool was removed.
Fig. 24
Fig. 25
-20-