K.
Final Assembly
Refer to Page PM16
1.
Rotate all shafts with shift shafts shifted to
all positions. Observe through cover
opening. Make sure there are no loose
tools, bolts or other foreign objects in the
assembly.
2.
Install cover gasket and cover, coat bolt
threads with Permatex, use a lockwasher
on each bolt and tighten to the specified
torque.
3.
If the transfer case was equipped with a
parking
brake,
remove
output
flange
(installed in step E10) and reinstall brake
assembly, output flange and drum.
4.
Install drain and fill plugs.
5.
Refer to Section "J" if case is equipped with
a PTO unit.
6.
Attach
all
mounting
brackets
before
reinstalling case in the truck. Refer to
Section III B of this manual for installation
instructions, to Section II for lubricant
instructions.
-28-