SERVICE MANUALFig. 2. Power Divider and Diff Carrier In Rebuild StandRemove Propeller Shafts1.Separate universal joints from companionflanges of input and output shafts of forward rearaxle.2.Repeat for input shaft of rear rear axle.Remove Output Shaft From Forward Rear Axle1.Remove output shaft bearing retainer bolts.2.Use soft hammer and loosen bearing retainerfrom axle housing.3.Withdraw bearing retainer and output shaft fromaxle housing.Remove Diff Carriers From Axle Housings1. Loosen differential carrier-to-axle housing bolts.Remove all bolts except top two.These two bolts will prevent carrier assemblyfrom falling.2.Support carrier assembly on roller jack. Secureas necessary to prevent carrier from falling fromjack when removed from housing.3.Remove top two carrier bolts. Loosen locknutsand turn puller screws in to break carrier awayfrom housing. A small pinch bar may be used tostraighten carrier assembly in housing, but becareful to avoid damage to carrier flange.Remove carrier assembly from axle housing.4.Roll jack and carrier assembly from under truck.Mount carrier assembly in suitable rebuild stand(Fig. 2).DISASSEMBLYFORWARD REAR AXLEDisassemble Power Divider From Diff Carrier1.Remove lockout control assembly (Fig. 3).Fig. 3. Removing Power Divider Lockout Control1Power Divider Lockout Control AssemblyCTS-4044PRINTED IN UNITED STATES OF AMERICAPage 4
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
