SERVICE MANUAL
Fig. 15. Removing Differential Bearing Caps
2
Differential Bearing Cap
3
Differential Bearing Cup
4
Bearing Adjuster
4.
Lift differential assembly from diff carrier (Fig.
16). Tilt differential assembly to allow ring gear
to pass pinion radial bearing. Place differential
assembly on bench.
Fig. 16. Lifting Differential From Carrier
Disassemble Differential
1.
If necessary, remove diff beariings from diff case
using suitable puller.
2.
Match mark diff case halves with a punch or
chisel
to
assure
correct
alignment
upon
reassembly.
3.
Remove self-locking nuts from diff case bolts
and separate the diff case halves (Fig. 17).
Fig. 17. Separating Diff Case Halves
1
Differential Case Halves
4.
Remove diff spider shaft, spider gears, side
gears and thrust washers from diff case halves
(Fig. 18).
Fig. 18. Differential Component Parts
1
Thrust Washer (2) 4
Differential Spider
2
Differential Case
5
Thrust Washers (4)
Halves
6
Side Gears (2)
3
Spider Gears (4)
CTS-4044
PRINTED IN UNITED STATES OF AMERICA
Page 9