ENGINE DIAGNOSTIC TEST PROCEDURESSection 6•SHUTOFF CABLE/ELECTRIC SHUTOFF400 Series On-Highway (withRobert Bosch MW Pumps)FROM FORM NO. CGED-365SHUTOFF CABLE OR ELECTRIC SHUTOFF4ADJUSTED TO ALLOW FULL RUN POSITIONMETHOD1st CHECK2nd CHECKVISUAL CHECK NOTE: If the shutoff cable is properly adjusted andelectric shutoff is properly adjusted and functional,enter OK in 1st check block. As necessary, adjustlinkage or solenoid and indicate correction inComments Section.I.SHUTOFF CABLE (MANUAL SHUTOFF)Visual CheckThe injection pump shutoff lever is spring loaded tothe run position. With the shutoff cable pulled out tostop the engine, the shutoff lever must contact theshutoff screw, as shown in Figure 6.AdjustmentTo ensure that the control rack is not restricted by theshutoff lever during engine operation, adjust the shutoffcable so it can be attached to the shutoff lever when thecable knob is fully sealed against the dash and theshutoff lever is turned fully counterclockwise (Full RunPosition).Figure 6. Shutoff Test(466 w/Robert Bosch MW Pump)CG ES-240-4Printed in United States of AmericaPage 16
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
