REPAIR INSTRUCTIONS USING FIBER GLASS MATERIALFigure 8. - V-Groove2.Remove flaky edges and feather the painted surfaceback about 1/2 inch beyond the damaged area byhand-sanding or power-sanding with 360 gritsandpaper (Figure 9).Figure 9. - Surface PreparationClean the area with a dry cloth or air.CAUTION - DO NOT WIPE WITHSOLVENT.3.Mask off the undamaged surface, leaving a workingarea of approximately 5 inches surrounding the repairarea (Figure 10).4.Following the manufacturer’s instructions, mix enoughbody filler to re-establish the surface (Figure 11).CAUTION - MIX FILLER ON FORMICA, TEFLON OROTHER HARD SURFACE. DO NOT WORK ON APOROUS SURFACE SUCH AS CARDBOARD.Figure 10. - Masking Undamaged AreaFigure 11. - Preparing Body Filler5.Apply and spread filler with a plastic squeegeemaking sure to remove large air bubbles (Figure 12).NOTE- Allow filler to extend above originalsurface to allow for shrinkage.Figure 12 . - Applying Body FillerCTS-4049Page 6
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
