REPAIR INSTRUCTIONS USING FIBER GLASS MATERIAL5.Power-sand the filler with 360 grit sandpaperuntil it is smooth and even with the originalsurface.6.If the filler is slightly porous (has fine pinholes),apply a thin coat of glazing putty (Figure 56). Ifthe filler is pockmarked, do not use glazing putty.In-stead, apply another layer of body filler ascovered in Steps 1 through 5 before applying theglazing putty.7.Allow the glazing putty to cure under heat gun orheat lamp. Finish by sanding with a sandingblock and 360 grit sandpaper.8.Clean the area with air and remask, if necessary.Then spot prime the surface and wet sand with400 to 600 grit sandpaper. Complete the repairby painting the surface.NOTE - If you have used screws to align the panel,remove them and fill the holes with body filler be-fore finishing the panel.Figure 56. - Applying Glazing PuttCTS-4049Page 17
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
