TM 5-3825-225-14&P
APPENDIX B
MAINTENANCE ALLOCATION CHART
Section I. INTRODUCTION
B-1. GENERAL.
a. This section provides a general explanation of all maintenance and repair functions authorized at the various
maintenance levels.
b. The Maintenance Allocation Chart (MAC) Section II designates overall authority and responsibility for the
performance of maintenance functions on the Identified end item or component. The application of the maintenance
functions to the end item or component will be consistent with the capacities and capabilities of the designated
maintenance levels.
c. Section III list the tools and test equipment (both special tools and common tool sets) required for each
maintenance function as referenced from Section II.
d. Section IV contains supplemental instructions and explanatory notes for a particular maintenance
function.
B-2. MAINTENANCE FUNCTIONS.
Maintenance functions will be limited to and defined as follows'
a. Inspect To determine the serviceability of an item by comparing Its physical, mechanical, and/or electrical
characteristics with established standards through examination (e.g., by sight, sound, or feel).
b. Test To verify serviceability by measuring the mechanical, pneumatic, hydraulic, or electrical characteristics of
an item and comparing those characteristics with prescribed standards.
c. Service Operations required periodically to keep an item in proper operating condition, i e., to clean (includes
decontaminate, when required), to preserve, to drain, to paint, or to replenish fuel, lubricants, chemical fluids, or gases.
d. Adjust To maintain or regulate, within prescribed limits, by bringing into proper or exact position, or by setting the
operating characteristics to specified parameters.
e. Aline To adjust specified variable elements of an item to bring about optimum or desired performance.
f. Calibrate To determine and cause corrections to be made or to be adjusted on instruments or test, measuring,
and diagnostic equipments used in precision measurement Consists of comparisons of two instruments, one of which is a
certified standard of known accuracy, to detect and adjust any discrepancy in the accuracy of the instrument being
compared.
g. Remove/Install To remove and install the same item when required to perform service or other maintenance
functions Install may be the act of emplacing, seating, or fixing into position a spare, repair part, or module (component
or assembly) in a manner to allow the proper functioning of an equipment or system.
h. Replace T o remove an unserviceable item and install a serviceable counterpart in its place. "Replace" is
authorized by the MAC and is shown as the third position of the SMR code
i. Repair The application of maintenance services, including fault location/troubleshooting, removal/ installation, and
disassembly/assembly procedures, and maintenance actions to identify troubles and restore serviceability to an item by
correcting specific damage, fault, malfunction, or failure in a part, subassembly, module (component or assembly), end
item, or system.
j. Overhaul That maintenance effort (service/ action) prescribed to restore an item to a completely
serviceable/operational condition as required by maintenance standards in appropriate technical publications (I.e.,
DMWR). Overhaul is normally the highest degree of maintenance performed by the Army. Overhaul does not normally
return an item to like new condition.
k. Rebuild Consists of those services/actions necessary for the restoration of unserviceable equipment to a like new
condition in accordance with original manufacturing standards. Rebuild is the highest degree of materiel maintenance
applied to Army equipment. The rebuild operation includes the act of returning to zero those age measurements
(hours/miles, etc.) considered in classifying Army equipment/components.
B-3. EXPLANATION OF COLUMNS IN
THE MAC, SECTION II.
a. Column 1, Group Number: Column 1 lists functional group code numbers, the purpose of which is to identify
maintenance significant components, assem-
B-1
