TM 5-3825-225-14&Pblies, subassemblies, and modules with the next higher assembly. End item group number shall be "00."b Column 2, Component/Assembly Column 2 contains the names of components, assemblies, subassemblies, andmodules for which maintenance is authorizedc. Column 3, Maintenance Function Column 3 lists the functions to be performed on the item listed in Column 2.(For a detailed explanation of these functions, see paragraph B-2 )d. Column 4, Maintenance Level Column 4 specifies, by the listing of a work time figure in the appropriatesubcolumn(s), the level of maintenance authorized to perform the function listed in Column 3 This figure represents theactive time required to perform that maintenance function at the indicated level of maintenance If the number orcomplexity of the tasks within the listed maintenance function vary at different maintenance levels, appropriate work timefigures will be shown for each level. The work time figure represents the average time required to restore an item(assembly, subassembly, component, module, end item, or system) to a serviceable condition under typical fieldoperating conditions. This time includes preparation time (including any necessary disassembly/assembly time),troubleshooting/fault location time, and quality assurance/quality control time in addition to the time required to performthe specific tasks identified for the maintenance functions authorized in the Maintenance Allocation Chart. The symboldesignations for the various maintenance levels are as follows.COperator or CrewOUnit MaintenanceFDirect Support MaintenanceHGeneral Support Maintenancee. Column 5, Tools and Equipment Column 5 specifies, by code, those common tool sets (not individual tools) andspecial tools, TMDE, and support equipment required to perform the designated functionf Column 6, Remarks This column shall, when applicable, contain a letter code, in alphabetic order, which shall bekeyed to the remarks contained in Section IV.B-4. EXPLANATION OF COLUMNS INTOOL AND TEST EQUIPMENT REQUIRE-MENTS, SECTION III.a Column 1, Tool or Test Equipment ReferenceCode The tool and test equipment reference code correlates with a code used in the MAC, Section II, Column 5b Column 2, Maintenance Level The lowest level of maintenance authorized to use the tool or test equipment.c Column 3, Nomenclature Name or identification of the tool or test equipmentd Column 4, National/NATO Stock Number The National or NATO Stock Number of the tool or test equipment.e Column 5, Tool Number The manufacturer's part numberB-5. EXPLANATION OF COLUMNS INREMARKS, SECTION IV.a. Column 1, Reference Code The code recorded in Column 6, Section IIb. Column 2, Remarks This column lists information pertinent to the maintenance function being performed asindicated in the MAC, Section II.B-2
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
