TM 5-3825-226-24
CRANKSHAFT REAR SEAL AND WEAR SLEEVE
REMOVE CRANKSHAFT REAR SEAL AND WEAR
SLEEVE
Tools Needed
A
B
C
1 P3075
Puller Assembly
1
5P7312
Distorter
1
5P7338
Ring
1
start by:
a) remove flywheel
1.
Remove the crankshaft rear seal from the
flywheel housing with tooling (A).
2.
Install tool (C) in the rear seal bore.
3.
Install tool (B) between tool (C) and the wear
sleeve. Turn tool (B) until the edge of the tool
makes a flat place (crease) in the wear sleeve.
Do this in two or more places until the wear
sleeve is loose.
4.
Remove tool (C) and the wear sleeve by hand.
INSTALL CRANKSHAFT REAR SEAL AND WEAR
SLEEVE
Tools Needed
A
5P7293
Installer
1
5P290
Locator
1
1P5515
Bolt
2
9S8858
Nut
1
1.
Install the crankshaft rear seal and wear sleeve
with tooling (A) as follows:
a)
Clean and make a preparation of the wear
sleeve inside diameter and crankshaft
outside diameter with 8M8060 Quick Cure
Primer. Make an application of 9S3265
Retaining
Compound
to
crankshaft
outside diameter and wear sleeve inside
diameter before the wear sleeve is
installed on the crankshaft.
b)
Install locator (3) and the bolts on the rear
of the crankshaft.
c)
Put clean engine oil on the lip of seal (1)
and install the seal on wear sleeve (2).
d)
Put 7F2770 Cement on the outer metal
surface of the seal.
e)
Put the wear sleeve (2) and seal (1) in
position on locator (3) with the outside
diameter bevel of the wear sleeve toward
the outside.
NOTE
Make sure the lip of the seal is
toward the front of the engine before
the seal is pushed in position as
shown.
f)
Put installer (5) in position on the locator.
g)
Put clean engine oil on the face of nut (4)
and install it on the locator. Tighten the
nut until installer (5) is at bottom.
h)
Remove tooling (A) and check the wear
sleeve and seal for the correct position
after installation.
end by:
a) install flywheel
3-130
