TM 5-3825-226-24
ENGINE
REMOVE ENGINE
Tools Needed
A
8S7620
Base Assembly
1
8S7650
Cylinder
1
8S7615
Pin
1
5P3100
Pump Group
1
start by:
a) remove radiator
b) remove oil pan
1.Tilt the cab as follows:
a)
Disconnect steering linkage (2) from steering
control valve (I).
b)
Remove the four bolts and nuts that hold left
rear fender (3) to the cab.
c)
Remove the panel assembly that is the support
for the rear of the hood.
d)
Remove pin (4) that holds the jack assembly to
the cab.
e)
Remove the pin that holds jack assembly (5) to
the storage bracket and put the jack assembly in
position on the tractor frame. Install the storage
pin through the jack assembly and hole (7) in
the frame.
f)
Put the top portion of the jack assembly in
position on the cab and install the pin to hold it.
g)
Remove bolt (6), the nut and the storage
bracket.
h)
Remove the bolt and nut that holds the right
front corner of the cab to the frame.
j)
Tilt the cab with jack assembly (5).
2.
Remove the oil level gauge from the engine.
3.
Remove plug (8) and drain the oil from the
torque converter. The torque converter capacity
is 6.5 U.S. gal. (24.6 litre).
3-131
