TM 5-3825-226-24
ENGINE REAR SUPPORTS
4.
Remove the engine support for the right rear as
follows:
a)
Remove bolt (9) and the nut from the
support assembly.
b)
Remove
the
upper
half
of
mount
assembly (8).
c)
Use tooling (A) to lift the engine enough to
take the weight off of support assembly (I
11). Remove bolts (10), the washers,
support assembly ( 11) and the lower half
of the mount assembly.
INSTALL ENGINE REAR SUPPORTS
Tools Needed
A
8S7630
Stand
1
8S7611
Tube
1
8S7615
Pin
2
8S7625
Collar
1
8S7650
Cylinder
1
5P3100
Pump Group
1
1.
Install the right rear engine support as follows:
a)
Put the lower half of the mount assembly
in position on the tractor frame.
b)
Put support assembly (2) in position and
install bolts (3) and the washers to hold it
to the flywheel housing. Make sure
ground cable (I) is in position before the
bolts are tightened.
c)
Put the upper half of the mount assembly
in position and install bolt (4) and the nut.
d)
Lower the engine with tooling (A) and
tighten bolt (4).
3-127
