TM 5-3825-226-24
TRANSMISSION
42.
Install pin (78), seal rings (77) and coupling (75)
in shaft assembly (76). Install the ring that
holds coupling (75) in shaft assembly (76).
43.
Install the seal ring on coupling (75).
44.
Install shaft assembly (76).
45.
Assemble No. 2 planetary carrier as follows:
a) Install the seal ring on carrier assembly (79).
b)
Install bearings (80) and (82) in each gear
(81).
c)
Put gears (81) in position in carrier
assembly (79) with washers (85) on each
side of the gears.
d)
Install shaft (83) in carrier assembly (79) to
hold gears (81) and washers (85) in position.
Make sure the holes in the shafts are in
alignment with the holes in the carrier
assembly.
e)
Install pins (84) even with the surface of
carrier assembly (79) to hold shafts (83) in
position.
46.
Lower the temperature of bearing (87) and
install it in plate (89). Make sure the notch in
bearing (87) is down when it is installed in the
plate. Install ring (86) to hold the bearing.
47.
Heat sleeve (88) in oil to a maximum
temperature of 275°F (135°C) and install it on
carrier assembly (79). Install the dowel in
carrier assembly (79) above sleeve (88). Install
the seal ring on sleeve (88).
48.
Put plate (89) on carrier assembly (79). Make
sure the notch in bearing (87) engages with the
dowel in carrier assembly (79). Install the ring
that holds plate (89) and carrier assembly (79)
together.
49.
Install plate (89) on the No. 2 clutch housing.
3-210
