TM 5-3825-226-24
TRANSMISSION
9.
Install pins (14) and springs (13) in the No. 6 clutch
housing assembly.
10.
Assemble No. 6planetarycarrier(15) as follows:
a)
Install bearing (16) in each gear (17).
b)
Put gears (17) in position in carrier (15) with
washers (20) on each side of the gears.
c)
Install shafts (18) in carrier (15) to hold gears
(17) and the washers. Make sure the holes
in the shafts are in alignment with the holes
in the carrier.
d)
Install pins (19) even with the surface of
carrier (15) to hold shafts (18) in position.
11.
Put No. 6 planet carrier (15) in position on the
clutch housing. Make sure the springs and pins are
in position and install the washers and bolts (24).
Tighten the bolts to a torque of 85 + 5 lb.ft. (115 +
7 N.m).
12.
Install sleeve (23), sun gear (22), the washer and
bolt (21). Tighten the bolt to a torque of 34 + 2
lb.ft. (45 + 3 N.m).
13.
Install plate (26) and No. 5 clutch ring gear (25).
14.
Install long pins (28), the two disc assemblies (27)
and plate (29). There must be a disc assembly on
each side of plate (29).
3-205
