TM 5-3825-226-24
TRANSMISSION
ASSEMBLE TRANSMISSION
Tools Needed A B
FT833 Clamp
2
FT834 Nozzle
1
1.
If necessary, make a replacement of dowels (3) in
No. 6 clutch housing (2) so they extend the same
height as the original dowels.
2.
Lower the temperature of bearing (4) and install it
in No. 6 clutch housing (2).
3.
Install ring (1) to hold bearing in position.
4.
Install the pistons and seal rings in all of the clutch
housings as follows:
a)
Put clean oil on the seal rings.
b)
Install seal rings (6) in the clutch housings.
c)
Install seal rings (7) in pistons (5).
d)
Make sure the seal rings are in the centers of
their respective grooves. Lightly push the
pistons into position in the housings.
CAUTION: Be extra careful when the pistons are installed
in the housings. Seal rings with damage or broken seal
rings can be the result of too much force used or the
pistons not in alignment with the housings.
5.
Install two 3/8"-16 NC forged eyebolts in No. 6
clutch housing (2) and install the clutch housing
and piston in the output transfer gear case.
6.
Install retainer (8), the three locks and tighten the
bolts.
7.
Install gear (9) and pins (11) in No. 6 clutch
housing.
8.
Install three disc assemblies (10) and two plates
(12). Start with a disc assembly.
204
