TM 5-3825-226-24
TRANSMISSION
49.
Install tool (B) to hold No. 3 clutch piston (58)
and the No. 4 clutch piston in position.
50.
Install two 1/2"-13 NC forged eyebolts in clutch
housing (55). Fasten a hoist and remove clutch
housing (55) the pistons and the two planetary
gear assemblies as a unit. Weight of the unit is
90 lb. (41 kg).
51.
Remove tool (B) and remove the pistons from
clutch housing (55).
52.
Remove the seal rings from the pistons.
53.
Remove bolt (59), the plate and the No. 3
carrier from clutch housing (55).
54.
Turn clutch housing (55) over. Remove ring
(63) that holds carrier (60) in position and
remove No. 2 carrier (60) from the clutch
housing.
55.
Remove ring (61) and bearing (62) from clutch
housing (55).
56.
Remove seal rings (64) from each side of the
clutch housing.
57.
Remove the pins and the ring from the groove
in No. 2 carrier (60).
58.
Push pins (66) into shafts (65) with a punch and
hammer.
59.
Remove shafts (65), gears (67) and the washers
from carrier (60). There is a washer on each
side of the gears. Remove the bearings from
the gears. Remove the pins from the shafts.
3-200
