TM 5-3825-226-24
TRANSMISSION
60.
Remove seal ring (68) from No. 3 carrier (71).
61.
Push pins (70) into shafts (69) with a punch and
hammer.
62.
Remove shafts (69), gears (72) and the washers
from carrier (71). There is a washer on each
side of the gears. Remove the bearings from
the gears. Remove the pins from the shafts.
63.
Remove springs (73) and pins (74).
64.
Remove No. 4 disc assemblies (75) and the
plates.
65.
Remove ring (76) and remove gear (77).
66.
Install tool (B) to hold No. 5 piston (79) in No. 5
clutch housing (78).
67.
Install two 7/16"-14 NC forged eyebolts in clutch
housing (78). Remove the clutch housing and
piston (79) by hand.
68.
Remove tool (B) and piston (79) from the clutch
housing. Remove the seal rings from the piston
and clutch housing.
3-201
