TM 5-3825-226-24
TRANSMISSION
21.
Assemble No. 4 planetary carrier as follows:
a)
Install seal rings (38) on carrier (45).
b)
Install bearings (39) and (41) in each gear
(40).
c)
Put gears (40) in position in carrier (45)
with washers (44) on each side of the gears.
d)
Install each shaft (42) in carrier (45) to
hold gears (40) and washers (44) in position.
Make sure the holes in the shafts are in
alignment with the holes in the carrier.
e)
Install pins (43) even with the surface of
carrier (45) to hold shafts (42) in position.
22.
Assemble No. 3 planetary carrier as follows:
a)
Install seal ring (46) on carrier (47).
b)
Install bearings (48) and (50) in each gear
(49).
c)
Put gears (49) in position in carrier (47)
with washers (53) on each side of the gears.
d)
Install each shaft (51) in carrier (47) to
hold gears (49) and washers (53) in position.
Make sure the holes in the shafts are in
alignment with the holes in the carrier.
e)
Install pins (52) even with the surface of
carrier (47) to hold shafts (51) in position.
23.
Lower the temperature of bearing (54). Install
the bearing in No. 3 and 4 clutch housing (55)
with the notch of the bearing down toward the
No. 3 clutch side of housing (55).
24.
Install ring (56) to hold bearing (54) in position.
25.
Install No. 3 planetary carrier (47) in the No. 3
and 4 clutch housing. Make sure dowel (57) in
the carrier is in alignment with notch (58) in the
bearing.
3-207
