TM 5-3825-226-24
BRAKE HEAD ASSEMBLIES
3.
Install the four pistons (3) in the bores of the
brake head through the boots.
CAUTION: The ends of the pistons must be through the
boots before the pistons are pushed into the bores or the
damage to the boots will be the result.
4.
Use tooling (A) to push the pistons in the bores.
Put the lip of the boots in the groove of the
pistons.
5.
Install the O-ring seals on the two caps (4) and
install the caps on the brake head.
6.
Put brake linings (5) in position and push pins
(7) in to hold them. Tighten bolts (6) to hold the
pins. end by:
a)
install brake head assemblies
3-287
