TM 5-3825-226-24
BRAKE MASTER CYLINDER AND ACTUATOR
(TRACTOR AND WATER DISTRIBUTOR)
REMOVE AND INSTALL TRACTOR BRAKE MASTER
CYLINDER AND ACTUATOR
1.
Disconnect hose assembly (1) and brake line (2)
from master cylinder and actuator (4).
2.
Remove four bolts (3) and remove master
cylinder and actuator(4).
3.
Put master cylinder and actuator (4) in position
under the front left side of the tractor frame and
install the bolts to hold it.
4.
Connect hose assembly (1) and brake line (2) to
master cylinder and actuator (4).
5.
Remove (bleed) the air from the hydraulic brake
system. See AIR REMOVAL FROM BRAKES
in TESTING AND ADJUSTING.
REMOVE AND INSTALL WATER DISTRIBUTOR
BRAKE MASTER CYLINDER AND ACTUATOR
1.
Disconnect wire (3) from alarm (1). Remove
bolts (2) fasten a hoist and remove the cover
assembly. Weight of the cover assembly is 135
lb. (61 kg).
2.
Disconnect hose assembly (5) and brake line (6)
from master cylinder and actuator (4).
3.
Remove four bolts (7) and remove master
cylinder and actuator (4).
4.
Put master cylinder and actuator (4) in position
in the water distributor frame and install the
bolts to hold it.
5.
Connect brake line (6) and hose assembly (5) to
master cylinder and actuator (4).
6.
Remove (bleed) the air from the hydraulic brake
system. See AIR REMOVAL FROM BRAKES
in TESTING AND ADJUSTING.
7.
Put the cover assembly in position on the water
distributor and install bolts (2) to hold it.
8.
Connect wire (3) to alarm (1).
3-288
