TM 5-3825-226-24
EMERGENCY AND PARKING BRAKE CHAMBER
REMOVE EMERGENCY AND PARKING BRAKE
CHAMBER
1.
Disconnect air line (2) from brake chamber
assembly (1).
2.
Release the parking brake with shop air
pressure of 70 psi (4.9 kg/cm2) or (480 kPa).
Remove the cotter pin and pin (3).
3.
Remove
two
nuts
(4)
and
lockwashers.
Remove the brake chamber assembly from the
machine.
INSTALL EMERGENCY AND PARKING BRAKE
CHAMBER
1.
Put brake chamber assembly (2) in position and
install the two lockwashers and nuts (1) to hold
it.
Make sure the warning plate on the brake
chamber assembly is toward the rear of the
machine and can be seen.
2.
Activate brake chamber assembly (2) with shop
air pressure at 70 psi (4.9 kg/cm2) or (480 kPa).
Connect the rod end to the parking brake lever
with pin (3) and cotter pin.
3.
Connect air line (4) to brake chamber assembly
(2).
3-291
