TM 5-3825-226-24
STEERING CYLINDERS
INSTALL STEERING CYLINDERS
1.
Fasten a hoist to the steering cylinder assembly
and put it in position on the machine.
2.
Install plate (3) and the bolts on the draft frame.
3.
Put washer (2) in position between the cylinder
assembly and draft frame.
4.
Install shaft (1), the plate and bolts to hold it.
5.
Put the cylinder rod and shims needed in
position.
6.
Install shaft (5), plate (4) and the bolts. Install
the fitting in the bottom of shaft (5).
7.
Remove the hoist from the steering cylinder
assembly.
8.
Connect hose assemblies (6) and (7) to the
steering cylinder assembly.
9.
Put clean grease in all fittings for the steering
system.
NOTE: Turn the machine from full right right to full
left several times to remove the air from the steering
system.
10.
Check the hydraulic oil and fill to the correct
level.
3-301
