TM 5-3825-226-24
BOWL AND EJECTOR CONTROL VALVE
DISASSEMBLE BOWL AND EJECTOR
CONTROL VALVE
Tools Needed
A
B
1P1857
Snap Ring Pliers
1
1P1856
Snap Ring Pliers
1
start by:
a) remove bowl and ejector control valve 1.
Remove four screws (1), retainers (3), rubber
seals (2) and the washers from the valve spools.
2.
Remove four bolts (4). Remove caps (5) and
(6) from the body. Remove cap (6) carefully
because of the three balls on the valve spool.
3.
Remove the O-ring seal from the front of cap
(5). Remove plug assembly (7), the spring and
the ring from cap (5).
4.
Remove sliding door cylinder valve spool (8)
and bowl lift spool (9) from the body. Remove
sleeve (10) from spool (8). Remove the two O-
ring seals from inside the body. Check the
condition of the seals. If the seals have
damage, use new parts for replacement.
5.
Remove snap ring (12) with tool (A). Remove
the washer, the spring and the plunger from
inside valve spool (8). Turn retainer (11) off
valve spool (8). Remove the piston assembly,
the spring and the two washers from the spool.
3-349
