TM 5-3825-226-24
BRAKE LININGS
REMOVE BRAKE LININGS
Tools Needed
A
8S7640
Stand
1
8S7611
Tube
1
8S7615
Pin
1
8S8048
Saddle
1
start by:
a)
remove rim and tire
1.
Remove the hydraulic jack used to lift the
machine to remove the tire.
2.
Install tooling (A) for safety.
3.
Loosen bolts (1) that hold the anchor pins in
position.
4.
Pull the anchor pins out of the head assembly
.75 in. (19.1 mm).
5.
Open the bleed valves to release any pressure
on the brake pistons.
CAUTION:
To prevent damage to pistons and seals, do not
make an application of the brakes when brake
linings are removed. The pistons must not move
out of their bores as the brake linings are removed.
If the pistons and seals move out of their bores, the
brake head must be removed to install the pistons.
6.
Remove the brake linings.
INSTALL BRAKE LININGS
Tools Needed
A
8S7640
Stand
1
8S7611
Tube
1
8S7615
Pin
1
8S8048
Saddle
1
1.
Push the brake pistons into the brake. This
gives clearance for the new brake linings.
2.
Install brake linings (1) in brake head assembly
(4).
3.
Push anchor pins (3) into brake head assembly
(4).
4.
Make sure there is .010 in. (0.25 mm) or more
distance between the anchor pins and wheel
disc.
Tighten bolts (2) to hold the anchor pins.
5.
Close the brake line bleed valves.
6.
Remove (bleed) the air from the hydraulic brake
system. See AIR REMOVAL FROM BRAKES
in TESTING AND ADJUSTING.
7.
Remove tooling (A). Put the hydraulic jack into
position used to lift the machine for tire
installation end by:
a)
install rim and tire
6-21