TM 5-3825-226-24
AIR CYLINDER, BRAKE MASTER
CYLINDER AND ACTUATOR
ASSEMBLE AIR CYLINDER
1.
Place the boot retainer (4) under the bushing (3)
and screw the bushing fully into the end cap (7).
2.
Install the seal (12) in the end cap (7).
3.
Install the felt' wiper (16) on the piston (17).
4.
Install the jam nut ( 1) on the rod (9).
5.
Screw the piston (17) tightly onto thr rod (9).
6.
Insert the rod (9) through the spring (10) and
into the bushing (3).
7.
Install the tube (15) over the piston (17) and
seat the tube in the end cap (7).
8.
Install the seal (14) in the head (13/.
9.
Install the head (13/on the tube (15).
10.
Install the studs (9) and secure with the
lockwashers (6) and nuts (5).
REMOVE
BRAKE
MASTER
CYLINDER
AND
ACTUATOR
1.
Disconnect the hose assembly (1) and brake
line (2) from the master cylinder and actuator
(3).
2.
Plug the two lines.
3.
Remove the four bolts (4) that secure the
master cylinder and actuator to the mounting
bracket (5).
INSTALL
BRAKE
MASTER
CYLINDER
AND
ACTUATOR
1.
Secure the master cylinder and actuator (3) to
the mounting bracket (5) with the four bolts (4).
2.
Unplug and connect the hose assembly (1) and
brake line (2) to the master cylinder and
actuator (3).
3.
Remove (bleed) the air from the hydraulic brake
system. See AIR REMOVAL FROM BRAKES
IN TESTING AND ADJUSTING.
6-16
