TM 5-3825-226-24
AIR CYLINDER CONTROL PANEL
WARNING: Release the pressure from the
pneumatic system before any work is done by opening
reservoir drain valves. Refer to Chapter 2, Section 4.
REMOVE CONTROL PANEL
NOTE: Tag and cap hose lines after removal.
1.
Disconnect the armored air control line (1) at the
water distributor (seven hose connections).
2.
Coil the control line and remove the control
panel (2) from the tractor.
INSTALL CONTROL PANEL
1.
Uncoil the control line (1) and mount the control
panel (2) in the tractor.
2.
Uncap and connect the seven hose lines at the
water distributor.
DISASSEMBLE CONTROL PANEL
1.
Remove the five screws (1), washers (2) and
nuts (3) that secure the panel halves.
2.
Remove the two capscrews (4) and washers (5)
that secure the hose clamp (6).
3.
Separate the panel halves.
4.
Replace valves (7), switch (8) and indicator
lamp as necessary.
ASSEMBLE CONTROL PANEL
1.
Install the valves (6), switch (7) and indicator
lamp.
2.
Mate the control panel halves and secure with
the five screws (1), washers (2) and nuts (3).
3.
With the hoses positioned for no strain, secure
the hose clamp (5) with the two capscrews (3)
and washers (4).
6-14
