TM 5-3825-226-24
LIFT CYLINDERS
3.
Lift the cylinder (2) into position and install pin
(3) as shown.
4.
Install the plates and bolts that hold pin (3) and
the rod end pin.
5.
Put carry check valve (4) in position on cylinder
assembly (2) and install the four bolts to hold it.
6.
Connect the hose assembly to the top of
cylinder
assembly (2).
7.
Fill the hydraulic system to the correct level.
DISASSEMBLE LIFT CYLINDERS
Tools Needed
A
B
C
1P510
Driver Group
1
1 P1784
Hydraulic Cylinder
Repair Stand
1
5P3100
Pump Group
1
1 P850
Torque Multiplier
1
1 P851
Adapter
1
1 P852
Adapter
1
start by:
a)
remove lift cylinders.
1.
Remove
the
bearings
from
the
cylinder
assembly
and rod assembly with tool group (A) and a
press.
2.
Put the cylinder in position on tooling (B).
3.
Slowly extend the cylinder to drain the oil out of
the cylinder. Install support (1) under the rod
and
fasten a strap around the rod to hold it in
position.
4.
Remove four bolts (2).
6-10
