TM 5-3825-226-24
AIR CYLINDER
WARNING: Release pressure from the
pneumatic system before any work is done by opening
reservoir drain valves. Refer to Chapter 2, Section 4.
REMOVE AIR CYLINDER
1.
Disconnect and cap the air supply line (1).
2.
Remove the cotter pin from each clevis (2), (3).
3.
While supporting the cylinder (4), remove each
clevis.
4.
Remove the cylinder from its mounting bracket.
INSTALL AIR CYLINDER
1.
Position the cylinder (4) in its mounting bracket
and install each clevis (2), (3).
2.
Install the cotter pin in each clevis.
3.
Uncap and connect the air supply line (1).
DISASSEMBLE AIR CYLINDER
1.
Remove the four nuts (5) and washers (6) that
secure the tube studs (8).
2.
Remove the head (13).
3.
Remove the seal (14) from the head (13).
4.
Remove the tube (15).
5.
Pull the rod (9) and attached parts from the end
cap (7).
6.
Remove the spring (10).
7.
Loosen the jam nut (11).
8.
Unscrew the piston (17) from the rod (9).
9.
Remove the felt wiper (12) from the piston (17).
10.
Remove the seal (12) and bushing (3) from the
end cap (7).
11.
Remove the boot retainer (4).
1.
Lock pin and chain assembly.
2.
Drive screw.
3.
Bushing.
4.
Boot retainer.
5.
Nut.
6.
Lockwasher.
7.
End cap.
8.
Stud.
9.
Rod.
10.
Spring.
11.
Jam nut.
12.
Felt wiper.
13.
Head.
14.
Seal.
15.
Tube.
16.
Seal.
17.
Piston.
6-15
