TM 5-3825-229-14&P
5-18. ENGINE WATER PUMP (cont)
a. Removal (cont).
(3) Remove two gaskets (7) and spacer (8) from engine.
(4) Remove preformed packing (10) and plugs (11, 12 and 13) from water pump.
b. Installation.
(1) Clean all old gasket material from cylinder head and water pump mounting surfaces.
(2) Apply a small amount of grease (GAA) to packing (1 0) and install packing in groove in water pump adapter on
cylinder head.
(3) Install plugs (11, 12 and 13) in water pump (4). Tighten plugs to a torque of 12 ft-lb (17 Nm).
(4) Place gaskets (7) with spacer (8) in position and install water pump (4) on engine. Secure water pump with
three washers (6) and screws (5). Tighten screws to a torque of 17 ft-lb (23 Nm).
(5) Install pulley (3) on shaft of water pump (4). Secure pulley to pump with washer (2) and screw (1). Tighten
screw to a torque of 17 ft-lb (23 Nm).
(6) Install fan and fan belt. Refer to para. 4-57.
5-51