CYLINDER HEAD AND VALVES (cont) - TM-5-3825-229-14P

CYLINDER HEAD AND VALVES (cont) - TM-5-3825-229-14P_305

TM-5-3825-229-14P Distributor Water Self-Propelled 2500 Gallon Capacity Sectionalized and Non-Sectionalized Models 613BWDNS Manual
Page Navigation
288

TM 5-3825-229-14&P 6-4. CYLINDER HEAD AND VALVES (cont) b. Installation (cont). NOTE Do not reuse valve stem seals. Each time the valves are removed from cylinder head, a new seal must be used when the valve is installed. (4) Coat inside of valve stem seal (6) with oil (OE/HDO). Push valve stem seal over valve stem and all the way down onto valve guide flange. CAUTION Do not remove valve after seal is installed. Valve can be withdrawn only as far as the groove in valve stem. Do not allow valve stem seal to come in contact with groove or seal damage may occur. (5) Using a valve spring compressor, compress each valve spring (4) and retainer (3). (6) Insert valve spring retainer locks (2). Remove valve spring compressor tool. Install valve stem cap (1). (7) Install cylinder head with new gasket (para. 5-7). 6-5. TAPPETS THIS TASK COVERS: a. Removal c. Installation b. Inspection INITIAL SETUP: Tools Required: Equipment/Materials Required: Lubricating Oil (Item 10, Appendix E) Nomenclature General Mechanics Equipment Conditions: Tool Kit Ref Conditions Micrometers 5-7 Cylinder head removed Personnel Required: 1 6-7

Privacy Statement
Press Release
Contact