TM 5-3825-229-14&P
6-5. TAPPETS (cont)
c. Installation (Cont).
NOTE
Hot plug face may not protrude more than 0.0026 in. (0.065 mm) from cylinder head. If this occurs, remove
hot plug and grind face of hot plug as necessary.
Hot plug face may not recede more than 0.001 in. (0.025 mm) from cylinder head. If this occurs, remove and
replace hot plug.
Hot plugs must be tight in hot plug bore. If they are not, remove hot plug and coat with pipe sealant and install
plug.
6-7. GEARCASE COVER
THIS TASK COVERS:
Equipment/Materials Required:
a. Removal
b. Installation
Lubricating Oil (Item 10, Appendix E)
INITIAL SETUP:
Equipment Conditions:
Tools Required:
Ref
Conditions
Nomenclature
4-58
Alternator removed
General Mechanics
5-6
Engine removed
Tool Kit
5-8
Crankshaft pulley removed
5-11
Screws and washers securing oil pan to
Personnel Required: 2
gear case cover removed
6-11
