CRANKSHAFT REAR OIL SEAL AND WEAR SLEEVE (cont)

CRANKSHAFT REAR OIL SEAL AND WEAR SLEEVE (cont) - TM-5-3825-229-14P_319

PISTONS AND CONNECTING RODS (cont) - TM-5-3825-229-14P_321

TM-5-3825-229-14P Distributor Water Self-Propelled 2500 Gallon Capacity Sectionalized and Non-Sectionalized Models 613BWDNS Manual
Page Navigation
302

TM 5-3825-229-14&P 6-10. CRANKSHAFT REAR OIL SEAL AND WEAR SLEEVE (cont) b. Installation (cont). (c) Rotate crankshaft one complete revolution. Note maximum runout. (d) If runout exceeds 0.0098 in. (0.25 mm), remove seal plate assembly and reposition seal in plate. (10) Install flywheel housing and flywheel (para. 5-10). 6-11. PISTONS AND CONNECTING RODS THIS TASK COVERS: a Removal d. Assembly b. Disassembly e. Installation c. Cleaning and Inspection INITIAL SETUP; Equipment/Materials Required: Tools Required: Lubricating Oil (Item 10, Appendix E) Cleaning Solvent (Item 13, Appendix E) Nomenclature Goggles (Item 9, Appendix E) General Mechanics Equipment Conditions: Tool Kit Ref Conditions Cylinder Ridge Reamer Plastic Tubing 5-7 Cylinder head removed Feeler Gauge 5-11 Oil pan removed Micrometers 5-12 Oil pump removed Oil Ring Expander Piston Ring Compressor Personnel Required: 1 a. Removal. CAUTION Removing carbon without a ridge reamer may cause damage to cylinder bore. (1) Remove carbon from top of cylinder bore and check for a ridge. Remove ridge with a ridge reamer before removing piston. 6-21

Privacy Statement
Press Release
Contact